Cable+Network Tester
Main Menu
11
Ping <options>
With the IP address of the Product automatically assigned or
configured in the Network setting, tap to open the Ping
screen to:
Enable or disable the Ping feature. Enabled is the default
setting.
With Ping enabled, use to:
Automatically do a Ping test after you do a network
switch test. Default Setting: IPv4 address 8.8.8.8
Use the saved protocol (IPv4 or IPv6) and enter a new
target IP address that uses the same protocol.
Delete an IPv4 target address to add and configure an
IPv6 target address or vice versa.
See Change the IP Address of a Device to Ping.
CDP/LLDP
Timeout
<options>
Tap to select the time in seconds to wait for a CDP/LLDP
response before the Product retries network discovery. The
default is 30 sec.
--
Use the slider bar at the right of the image to adjust the
brightness of the image.
Auto
Shutoff
The Product turns off after 15 minutes of no use. While the
Product charges, Auto Shutoff is disabled. Default setting.
The Product remains on until the battery needs to be
charged again.
Sound
The Product emits an audible sound at the completion of a
test. Default setting.
The Product does not emit an audible sound at the
completion of a test.
Numbers -- Set or view the decimal point indicator.
Units -- Set or view the units to use in measurements.
Table 6. Settings Menu (cont.)
Option Menu Option Description
To Next Page
Loading...
