Fluke LinkIQ - Page 14

LinkIQ
Users Manual
10
NVP <options>
Set the Nominal Velocity of Propagation (NVP) value based
on the cable. NVP value range is 50-99. The default NVP
value is 68.
General Settings
Auto
Increment
Automatically increments the Test ID by one number or letter
for the next test. Default setting.
Use to manually increment or edit the Test ID.
PoE Test
Enable PoE detection. Use to automatically do a PoE test
after you do a network switch test. Default setting.
Disable PoE detection. Use to decrease the time to do a
switch test.
Network <options>
Tap to se le ct:
 DHCP to automatically assign an IP address to the
Product.
 Static to configure the IP address, Subnet Mask,
Gateway, and DNS of the Product. See Change the IP
Address of the Product.
The default settings are:
IPv4 Address:
DHCP
IP, Gateway, and DNS addresses: 0.0.0.0
Subnet Mask: /24 (255.255.255.0)
IPv6 Address:
DHCP (which is SLAAC/DHCPv6 for IPv6)
IP, Gateway, and DNS addresses: ::0
Subnet Mask: /64
Table 6. Settings Menu (cont.)
Option Menu Option Description