LinkIQ
Users Manual
28
Item Description Funcition
Advertised
speeds
Shows the advertised speeds of the device and whether they
have full-duplex or half-duplex capability at the advertised speed.
Speeds in black indicate the switch advertises that speed.
Speeds in gray indicate the switch does not advertise that speed.
Full Duplex
A check mark (
Y) indicates the device can send and receive
communication simultaneously at the advertised speed.
A dash (—) indicates the device does not have full-duplex
capability at the advertised speed.
Half Duplex
A check mark (
Y) indicates the device can send and receive
communication but not simultaneously at the advertised speed.
A dash (—) indicates the device does not have half-duplex
capability at the advertised speed.
A blank space indicates that half-duplex capability is not available
at the advertised speed.
Ping summary
button
This button shows only when Ping is enabled.
: Indicates the test passes.
: Indicates the test fails.
The maximum round trip time in ms of the 4 ping attempts or
-- ms if no ping attempts are successful.
The IP address of the device on the network that is pinged.
Tap to open the Ping screen to view detailed ping results. See
Ping Test Results.
PoE test results
PoE results show only when PoE is on and the Product is
connected to a PoE device. If needed, scroll down to see all the
results. See PoE Test Results.
Table 11. Switch Test Results (cont.)
To Next Page
Loading...
