Cable+Network Tester
Switch Test Results
33
Item Description Function
Powered pairs Shows which pairs have power.
HW: Class
The hardware negotiated power class (Class 0 to Class 8) of the
PSE device.
Watts at PD The loaded power in watts provided by the PSE at the PD.
Volt minimum
The minimum required volts the device needs to meet under load
per the IEEE 802.3 standard based on the HW negotiated power
class (
).
Volts under load
Measured voltage under load at reported power draw.
: Indicates the voltage meets the requirements for the HW
negotiated power class (
).
: Indicates the voltage does not meet the requirements for
the HW negotiated power class (
).
Or,
The switch under test cannot deliver power to the device
because the maximum power which the switch can deliver is
already in use.
SW Negotiated
Class:
The software negotiated power class (Class 1 to Class 8) of the
device.
This section does not show information, If:
The device does not support the voltage required to meet
the HW negotiated power class.
The device does not support software negotiation.
Watts at PD The loaded power in watts provided by the PSE at the PD.
Table 14. PoE Test Results (cont.)
To Next Page
Loading...
