MPS450 SERVICE MANUAL SAFETY CONSIDERATIONS
iv
Safety Considerations
Authorized service personnel should service Fluke Biomedical's MPS450 Multiparameter Simulator
(hereafter referred to as the MPS450). For safety reasons, although the power output from the MPS450 is
not potentially dangerous, only an experienced technician should open the unit to access the inner
electronics.
The following warning and informational symbols may be found on the MPS450:
Symbol
Description
Direct Current
Caution
(Refer to accompanying documentation.)
ON/OFF
(Toggle for power connection/disconnection for
operation.)
Hazard Warnings
⇒ Warning! Internal Voltage. Always turn OFF the MPS450 and unplug the battery
eliminator before replacing the batteries or cleaning the outer surface.
⇒ Warning! Liquids. Avoid spilling liquids on the instrument; fluid seepage into internal
components creates corrosion and a potential shock hazard. Do not operate the
instrument if internal components are exposed to fluid.
Precautions
⇒ Caution: Environmental Conditions. Do not expose the instrument to temperature
extremes. Ambient operating temperatures should remain between 10 to 40 °C. Storage
temperatures should remain between -25 to 50 °C. System performance may be
adversely affected if temperatures fluctuate above or below these ranges, or if ambient
humidity exceeds the maximum of 80 %.
⇒ Caution: Do NOT Immerse. Clean only with a damp, lint-free cloth. Use a mild
detergent and wipe down gently.
To Next Page
Loading...
