Fluke TS54 TDR - Storing the Number You Are Calling; Dialing a Number with the Speed Dial Function; Dialing a Number from the Phone Book; Dialing a Number from the Call Log

16
TS54TDR/TS53 PRO Test Sets
Users Guide
Storing the Number You are Calling
After you dial a number, you can save it in one of the
memory locations for the speed dialing function:
1 Connect the test set to a working telephone line.
2 Press P, then dial the number.
3 Press M, then press the number key (1 through
9) to select a memory location.
Dialing a Number with the Speed Dial Function
1 Connect the test set to a working telephone line.
2 Press P.
3 When the test set goes off-hook, press R then the
number key (
1 through 9) for the memory
location. For example, to dial the number stored in
location 5, press R and then 5. The test set shows
and automatically dials the number.
Dialing a Number from the Phone Book
1 Connect the test set to a working telephone line.
2 Press M twice to see the CALL PHNBK.
3 Press Cor D to put the flashing cursor next to
the name for the number you want to dial.
4 Press P. The test set goes off-hook, then dials
the number.
Dialing a Number from the Call Log
The call log is a list of phone numbers for the last 10
calls that the test set made or received. If you make or
receive a call from the same number more than one
time, the number shows only one time in the list.
To dial a number from the call log:
1 Connect the test set to a working telephone line.
2 Press M, press D to put the flashing cursor next
to
Call Log, then press M again.
3 Press C or D to put the flashing cursor next to
the number you want to dial.
4 Press P. The test set goes off-hook, then dials
the number.
DTMF Digit Grabbing
The test set lets you capture DTMF (Dual-Tone Multi-
Frequency) tones generated on a telephone line. This
feature is useful when you suspect that the customer’s
equipment is not generating proper DTMF signals.
The test set detects tones for 0 through 9, *, and #.
To use the Digit Grabbing mode:
1 Connect the test set to the Tip and Ring of the line
that is connected to the customer equipment.
2 Press Q.
3 Press M, press D to put the flashing cursor next
to Digit Grab, then press M.
4 Put the equipment into tone dialing mode, then
take it off-hook.
5 Dial a number on the equipment. The number
shows on the test set display.
6 Verify that the number on the display is the same
as the number you dialed.
7 To exit Digit Grabbing mode, press M, or press
P then Q, or turn off the test set then turn
it on again.