FLYBOX
Operating Instructions
REV 1.0
25
®
APR1- User Manual,
Safety Instructions and Warning Booklet
- ADV+ > Advance Plus mode
This function is available in models APR1-M-LC (MAP -
low current) and APR1-M-HC (MAP - high current) only.
The APR1 adjusts the engine speed according to the
Speed/RPM and also to the MAP/RPM curves set by the
installer.
In this mode, the instrument recognises the various ight
phases according to the speed of the aircraft, and when
the speed changes, it quickly makes the RPM changes by
changing the propeller pitch.
When operating in this mode, it will still be possible to vary
the RPM as desired, by acting on the knob or in any other
possible mode among those available and if activated. Go
to chapter 4.3.2 for a full description.
Because the ADV+ mode continuously monitors the MAP
value, in certain situations the RPM can be increased
automatically to prevent overtorque conditions.
If you own the -M- model and your installer has set a MAP/
RPM curve in your device, you can select this mode of
operation. The ADV+ item will not be available in the menu
for models without a MAP sensor.
The -M- versions are equipped with a Manifold pressure
absolute sensor and through an editable curve MAP/RPM,
the RPM are automatically increased if by pushing the
throttle the MAP value became too high for the current
RPM. This to avoid engine overtorque.
To Next Page
Loading...