Flybox APR1 - Use in ADV+ (Advanced Plus)

FLYBOX
General Suggestions
REV 1.0
43
®
APR1- User Manual,
Safety Instructions and Warning Booklet
5.3 Use in ADV+ (Advanced Plus mode)
In Advanced Plus mode, the APR1 regulator will
automatically set the engine revs following the Speed/
RPM curve and also to the MAP/RPM curve set by your
installer.
After setting the ADV+ control mode, see chapter 4.3.1,
you can follow the advice below if you want to use APR1
in this automatic mode.
At start-up, the instrument will automatically set the target
rpm to the maximum value set by your installer, e.g. 5700
or 5800 in case of Rotax or another RPM in case of a
dierent engine.
Before takeo, always do the Propeller test in automatic
mode as expected and explained in chapter 4.1.
This is to check that the APR1-propeller system is working
correctly and if something goes wrong, do not take o but
check what the problem might be and if necessary call
your technician.
When the the Propeller Test is nished, check that the
green idle pitch light is lit and that the target RPM on the
display is the maximum RPM for takeo.
During the takeo run, in addition to checking the
increasing aircraft speed, it is mandatory to check if the
motor is giving the target RPM for takeo. Remember that
the target RPM shown on APR1 are not the engine RPM.
The engine RPM must be checked on the aircraft
tachometer and not on the APR1 screen.