Flybox APR1 - Backup;Restore

To Next Page

To Previous Page

4.5 Backup/Restore

All set parameters and calibrations made in the instrument

can be saved in a backup le. This can be useful if you

need to restore all the parameters in a new instrument, for

example in case of replacement, or if you need help from

your installer. In this case, simply send the backup le

saved on the USB stick to your installer for a support

service. To backup or restore the parameters it is

necessary to connect a USB pen drive to the instrument.

From the main menu of the instrument, choose “Backup/

Restore”. If the USB stick is not plugged-in yet, the

message “Insert Flash Drive” will appear.

If already plugged-in, a message indicating to choose the

operation will appear:

Select

“Backup” to

proceed

Message

during

Writing

Message

when

nished

NOTE: A backup le is now written on the pen drive, copy

it to a safe place for future use.

NOTE: The USB stick must be free from any le before

saving a Backup le.

FLYBOX

Operating Instructions

REV 1.0

APR1- User Manual,

Safety Instructions and Warning Booklet