4.4 Firmware Upgrade
The APR1 software can be easily updated with new
versions, when available. It is advisable to check often
whether a new software version is available, going to
www.yboxavionics.it under “support > software” page.
Download the new version and if the le is compressed
(zipped), after unpacking it, copy it to a USB stick, possibly
free from other les. To update the instrument it is
necessary to connect the USB stick to the instrument, then
from the main menu select “Firmware Upgrade”.
If the USB stick is not yet plugged-in, the message
“Insert Flash Drive” will appear.
If already plugged-in, a message indicating the SW
versions will appear:
Select “YES”
to upgrade
This will appear
after upgraded
Wait until the “done” message will appear then remove the
USB stick. The instrument will reboot with the new
software.
NOTE: The USB stick must contain the new rmware le
only.
FLYBOX
Operating Instructions
REV 1.0
32
®
APR1- User Manual,
Safety Instructions and Warning Booklet
To Next Page
Loading...