FLYBOX
General Suggestions
REV 1.0
42
®
APR1- User Manual,
Safety Instructions and Warning Booklet
NOTE: The internal safety circuit oers a by-pass of the
electronics. In the event of a fault, and if there are no
problems in the cables or hub, you will always be able to
position the pitch so that you can reach the landing. Don't
take o again if you haven't xed the fault rst.
Remember that when in “constant speed”, in addition to
turning the knob, you can also change the target RPMs
with the INC/DEC switch and by other means (if your
installer has provided them). See Chapter 4.3.2 for more
information.
In manual position, remember to set the maximum RPM
especially on landing as well as takeo. You may need to
go around or do a touch & go and you will end up with all
the RPM and power you need.