Doc No: OMM50002312
Rev: C Page 33 of 54
Subject to contractual terms and conditions to the contrar
y, this document and all the information contained herein are the confidential and exclusive
property of FMC Technologies, and may not be reproduced
, disclosed, or made public in any manner prior to express written authorization by FMCTI.
10.3.3 Valve Removal and Installation Tools
There are two Knock Out tools available for removing valves from W11 pumps. The
P534695 Small Ball Knock Out tool is the preferred tool for W11 pumps with ball valves.
The P534694 Large Ball Knock Out tool is designed for the disc valves in the W11
pumps. The valves and appropriate tools are listed in Table 9.
Figure 6: Illustration of the P534694 or P534695 Ball Valve Knock Out Tools
All Knock Out tools are used as illustrated in Figure 4, Section 10.3.1. The P534694 or
P534695 ball type tools are used with the ball end positioned against the bottom of the
valve seat.
To Next Page
Loading...