Focal Dimension - Page 25

DIMENSION
User manual
•
No sound is coming from the
The cable has not been
Check
the cable
subwoofer connected to the
connected correctly or there's
is connected correctly.
Page
24
SUB LINE OUT a fault with the cable.
The "SUBWOOFER"
selector
Check that the
setting is positioned "SUBWOOFER" selector is
Page
17
set to 12- SUB LINE OUT.
The subwoofer used is
Check
your active subwoofer
set to OFF, Standby or is
is
working correctly.
I
The CEC via the HDMI™ The CEC command via
Enable
this function on
connections are not working
HDMI™ is deactivated on your the audio-video devices Page 25
audio-video devices.
connected to
Dimension.
At least one of your devices is
not equipped
with this control
I I
function.
The audio and the video are
Your
TV is not equipped with
Use Dimension's manual
not synchronised.
an
automatic synchronisation
"SYNC" function.
Page 26
function.
Dimension is not within reach
The reach
of the remote
The remote control is not
of
your remote control or the
control is approximately
I
working.
angle is too extreme.
7 metres. The maximum
is 20°.
The
battery in your remote
Replace the battery. Page 10
control is low.
Your
TV is equipped with
Refer to your TV's user
the Audio Return Channel
The Audio Return Channel
function but there's no sound
function on your TV is
manual and enable the
Page 18
TV's Audio Return Channel
when Dimension's TV input is
deactivated.
function.
selected.
The
HDMITM cable has not
Check
connections are
been Cqf.lnected
incorrectly or correct. If the problem
Page 18
a there's a fault
persists, try another HDMI™
with the cable. cable.