18
Pro Tools Setup
• From the Pro tools menu bar, go to:
Setup > Playback Engine...
• In the Playback Engine menu pop-up,
select: ‘HD Native’
The following steps are optional but will simplify signal routing:
• From the menu bar, go to: Setup > I/O Setup...
• Ensure your input and output routing tables are routed as follows by selecting the Default tab at
the bottom left of the page.
Notes
1. The number of input and output channels available is dependent on the sample frequency (see channel allocation
tables in Appendix 2, pages 24–26
2. The Loopback input is not available on the Pro Tools host mode
3. Output routing using Focusrite Control is not available in the Pro Tools Host mode
To Next Page
Loading...
