6
Plumbing
3/8" OD push-in water inlet
3/4" MPT drain
3/8" FPT condenser inlet (water-cooled condenser only – 1.25 gpm minimum available ow)
3/8" FPT condenser drain (water-cooled condenser only)
Notes: Slope to drain of 1/4" per foot (6mm per 30.4cm run) with a 1/2" min. is recommended.
Water shut-off recommended within 10 feet (3m), drain to be hard piped and insulated.
Separate drains for ice machine and condenser. To prevent back ow, do NOT connect drains.
Follett recommends installation of an activated carbon lter in ice machine inlet water line.
Ambient
Air temperature 100 F/38 C max. 50 F/10 C min. (best performance below 80 F/27 C)
Water temperature 90 F/32 C max. 40˚F/4˚C min. (best performance below 70 F/21 C)
Water pressure 70 P.S.I max. (482 kPA) 10 P.S.I. min. (89 kPA)
To Next Page
Loading...
