7
7
.
.
3
3
S
S
y
y
s
s
t
t
e
e
m
m
T
T
e
e
s
s
t
t
i
i
n
n
g
g
1. Connect the power source to the receiver and test the MAIN relay output (red EMS button)
and observe that it properly opens and closes the main line.
2. Test the operation of each function to ensure it corresponds to the transmitter direction
labels and/or the pendant it is replacing.
3. Test the limit switches on the crane and verify that they are working properly.
4. If your new remote control is replacing an existing pendant make sure it is completely
disconnected to prevent unwanted control commands.
5. If your new remote control is replacing an existing pendant make sure the pushbutton is
stored in a safe location where it will not interfere with remote operation.
To Next Page