Fomotech Alpha 608A - Α612 Receiver Function Settings

- 25 -
Short
* 4 pushbuttons: When either relay of pushbutton 1~4 is
activated, LV relay will also be activated.
* 8 pushbuttons: When either relay of pushbutton 1~6 is
activated, LV relay will also be activated.
* 12 pushbuttons: When either relay of pushbutton 1~8 is
activated, LV relay will also be activated.
JP3(*2)
α608T only
Open
MAIN relay off, I & II relays remain unchanged
Short
MAIN relay off, I & II relay off.
JP4
Open
7
th
AUX: “Normal” pushbutton setting
Short
7
th
AUX: “Toggle” pushbutton setting
“Start” means: MAIN relay unlatches and then latches.
※ Open → no Jumper Short → put Jumper
Remark 1：The setting of auto shutdown time can be done by manufacturer or distributor. Setting range:
0~30 minutes. (In-plant setting: 5 minutes)
Remark 2：When the transmitter voltage is low, LV relay will be activated and siren or lights will be ON.
(One second of interval)
Remark 3：Every time when you change jumper settings you must first turn the receiver power off and then
turn it back on so that the new settings can be stored in memory.
7.3.2 α612 Receiver Function Settings
7.3.2.1 Set by programming tool
7.3.2.2. Adjust Jumper setting function by decoder board
R
R
e
e
c
c
e
e
i
i
v
v
e
e
r
r
f
f
u
u
n
n
c
c
t
t
i
i
o
o
n
n
s
s
e
e
t
t
t
t
i
i
n
n
g
g
s
s
:
:
Jumper Set table: In-plant setting (default).
JP1
(Mode 0)
Open
Transmitter 11th pushbutton (AUX) start (when
MAIN relay is off)
Short
Transmitter power switch start (when MAIN relay is
off)
JP2
(Mode 0)
Open
No auto shutdown time on Main relay
Short
The receiver MAIN will be deactivated after
consecutive 5 minutes of standby time.
JP3
Open
When the transmitter voltage is low, LV relay
activates/deactivates every second.
Short
When either relay of pushbutton 1~8 is activated, LV
relay will also be activated.
“Start” means: MAIN relay unlatches and then latches.
Mode 1: 1. JP1 setting is invalid. The system is startup by power switch start.
2. JP2 setting is invalid. The MAIN relay auto shutdown time is set by the transmitter.
※ Open → No jumper Short → Put Jumper
Remark 1：The setting of auto shutdown time can be done by manufacturer or distributor. Setting range:
0~30 minutes. (In-plant setting: 5 minutes)
※ Prior to Jumper setting, be sure to first switch off the system to set.
※ Please take out the batteries from the battery compartment when the transmitter is not operated for a
longer time, otherwise the batteries may leak and cause malfunction to the transmitter.