EN-13
Reviewing Test Results
Your device stores the 1000 most recent test results along
with respective dates and times in its memory. To enter the
device memory, start with the device switched o.
To review all test results, do the following:
1. Press and release MAIN button or . The “ ” icon
appears on the screen.
2. Press MAIN to review the test results stored in the device.
Press or repeatedly to review other test results stored
in the device. After the last test result, press MAIN again
and the device will be turned o.
Note:
• Control solution test results are stored in the memory.
• The control solution range printed on the test strip vial or
individual foil pack is for control solution use only. It is not
the recommended range or reference values.
• Refer to the Maintenance section for important
information about your control solutions.
Out-of-range results:
If you continue to get results that fall outside the range
printed on the test strip vial, it means that the meter and
strips might not be working properly. Please contact your
local customer service or place of purchase for assistance.
(100 mg/dL = 5.5 mmol/L; 200 mg/dL = 11.1 mmol/L)
To review the day-average test results, do the following:
1. Press and release to enter memory mode for average
results with “ ” and displayed on the screen.
Release MAIN and then your 7-day average result
measured in general mode will appear on the display.
2. Press or to review 14, 21, 28, 60 and 90-day average
results stored in each measuring mode in the order of Gen,
AC, then PC.
To Next Page
Loading...
