12
Test Strip
NOTE
The FORA D40 monitor should only be used with FORA D40 Test Strips.
Using other test strips with this meter can produce inaccurate results.
ATTENTION:
The front side of test strip with FORA Logo
should face up when inserting test strip.
Test results might be wrong if the contact bar
is not fully inserted into the test slot.
Front
Absorbent Hole
Apply a drop of blood here.
The blood will be automatically absorbed.
Conrmation Window
This is where you confirm if enough blood
has been applied to the absorbent hole in
the strip.
Test Strip Handle
Hold this part to insert the test strip into
the slot.
Contact Bars
Insert this end of the test strip into the
meter. Push it in firmly until it will go no
further.
1
4
3
2
To Next Page
Loading...
