41
Always apply the pressure cuff before turning on the monitor.
Measurement Average Mode
Step 2
After the first measurement is complete, the monitor will start count-
ing down before the second measurement begins. The number on the
right represents the remaining countdown between each measure-
ment. The monitor will take three (3) measurements consecutively
with an interval of 20 seconds.
Step 1
Press and hold
for 3 seconds (for FORA D40b and D40g), or just
press
(for FORA D40a). The monitor will turn on and enter the
averaging mode. Press
to select the desired user number and then
press
. Then the cuff will begin to inflate automatically.
To Next Page
Loading...
