Filling the Sealing Liquid Reservoir
When you want to seal envelopes, the sealing liquid reservoir must be filled.
1.
Press the button to open the system (see “Operating Controls” ).
2. Lift the sealing liquid reservoir D with the blue handles A carefully out of the system.
3. Remove the strip C from the reservoir.
4. Fill the three reservoirs with sealing liquid.
5. Make sure the brushes B are moistened sufficiently.
6. Replace the liquid reservoir.
7. Close the system.
Before you start the job, wait approximately 5 minutes for the brushes to moisten.
4
English
31
| Page 31 | Jan-15-2019 03:21 | Loading the System
To Next Page
Loading...