Moistening position
If the moistening area of the envelope is not correctly moistened, adjust the moistening
position as follows:
Go to the supervisor menu.1.
2. Tap [Adjust moistening position].
3. Choose the envelope type to setup and tap the arrow button.
4. Use the arrow buttons up/down to adjust the moistening position.
5. Tap the [1x] button to test the new position.
6. Repeat step 4 and 5 until the envelope position is correct.
7. Tap the [OK] button if the position is correct.
WiFi Settings
Proceed as follows if you want to connect the system to an available WiFi network:
Go to the supervisor menu.1.
2. Tap [WiFi Settings].
3. This screen will be shown if the system is not connected. Tap the "pencil" button to
see if WiFi networks are available.
5
English
37
| Page 37 | Jan-15-2019 03:21 | Settings menu
To Next Page
Loading...