Formlabs Fuse Blast - Introduction; Intended Use

10
2 Introduction
2.1 Intended use
The Fuse Blast is a commercial, precision tool intended for use in the additive manufacture of
end-user supplied designs from SLS powder. The final performance characteristics of sintered
SLS powder may vary according to your compliance with the instructions for use, application,
operating conditions, material combined with, end use, or other factors.
The Fuse Blast is not for residential use.
In some cases, the additive manufacturing process may inherently result in variable
performance characteristics between manufacturing runs or within a specific part.
Such variances may not be apparent and may result in unexpected defects in
additively fabricated parts.
IPX0: The product oers no special protection from water.
The Fuse Blast is classified as Pollution Degree 2: Normally only nonconductive
pollution occurs. Temporary conductivity caused by condensation may be expected.
You shall independently verify the suitability of additive manufacturing, Selective
Laser Sintering (SLS), the Fuse Blast, and any specific designs or materials employed
for the application and intended purpose before use. In no event shall Formlabs be
liable for any loss, death, or bodily injury that you suer, or that you cause to any third
party, in connection with your use of Formlabs products. To the fullest extent legally
permitted Formlabs EXPRESSLY DISCLAIMS ANY IMPLIED OR EXPLICIT WARRANTY
OF FITNESS for a particular usage, the particular nature and circumstances of said
usage being unforeseen and unforeseeable to Formlabs.
Formlabs provides tools and materials that may be used in many applications, but
makes no claims as to the safety or eectiveness of any specific devices made using
Formlabs products. Certain Formlabs products, such as those commonly known in the
industry as “biocompatible” materials, have been engineered to comply with relevant
industry standards. The specific standards and most relevant technical specifications
may be identified within the technical data sheets and have been tested according
to relevant testing protocols for those standards and specifications. Biocompatible
materials are a speciality product, developed for use by medical professionals, and
should be used in accordance with the instructions for use.
Do not modify. The Fuse Blast is intended for use as-is. Modifying the machine without
explicit approval and directions from Formlabs or a certified service provider will void
your warranty, and could potentially ruin the machine and cause you bodily harm.
NOTICE
NOTICE
NOTICE
NOTICE
WARNING
WARNING
WARNING