Formlabs Fuse Blast - Accessing the Serial Name; Installing the Machine

22
4.4 Accessing the serial name
For detailed guidance and visual assistance, visit support.formlabs.com.
The serial name is a unique identifier used to track the history of manufacturing, sales, and
repair. The serial name for the Fuse Blast is located on a sticker next to the A/C input on the I/O
panel in the format Blast-AdjectiveAnimal. For a Fuse Blast, the serial name is also available
on the touchscreen on the top-left corner of the home screen.
To access the serial name on the touchscreen:
1.
Tap the gear icon in the bottom-left corner to enter the Settings menu. The Settings
menu appears.
2. Tap System. The System screen appears.
3. Tap Device Details. The Device Details screen appears.
4. The serial name is listed in the top-left corner.
4.5 Installing the machine
For detailed guidance and visual assistance, visit support.formlabs.com.
After selecting a dry, indoor location for the Fuse Blast, install the accessories if you did not do
so during the unboxing process: insert the tumbler basket, connect the blast gun to the blast
arm, connect the air compressor cables, connect the foot pedals, install the Wi-Fi antenna,
check the valves, and then connect the Fuse Blast to a power source to turn on the machine.
4.5.1 Installing the tumbler basket
Remove the Fuse Blast tumbler basket from the pallet. Open the blasting cabinet, and locate
the basket shaft on the back wall of the cabinet interior. Using two hands, carefully and firmly
slide the tumbler basket onto the tumbler basket shaft until the position bottoms out. The shaft
lays flush on the basket interior.
4.5.2 Installing the blast gun
The blast arm is wrapped and zip tied in the home position. Cut the zip ties to release the gun
and remove the packaging. To move the arm into the blasting position, pull the arm forward
from the home position, then to the left to rest in front of the tumbler basket.
Ensure that the tubing is free to move and unobstructed.
4.5.3 Attaching the grounding strap
Remove the grounding strap from the accessories box and attach it to the grounding port on
the front right leg of the Fuse Blast.
4.5.4 Connecting the foot pedals
Place the floor mat underneath the Fuse Blast. Place the foot pedals on the floor mat underneath
the Fuse Blast. Attach the cable to the I/O panel to the rear of the machine.
4.5.5 Connecting the compressed air supply
Attach your air compressor to the Fuse Blast using the compressed air inlet. The compressed
air supply must be regulated to between 90–120 psi. Do not set the air compressor above
120 psi.
The Fuse Blast contains a pressure relief valve to protect the hardware from air
pressures higher than 120 psi. If the compressed air supply is above 120 psi, the
pressure relief valve will release and make a loud hissing noise, even if the machine is
turned o.
NOTICE