Preparation and setup | 21
4.3.2 Unboxing
The custom packaging the Fuse Blast arrives in is specially designed to protect the machine
during shipping. During unboxing, inspect the product for any damage or missing items. In the
case of damage or missing items, contact Formlabs Support or a certified service provider.
Removing the machine from its packaging requires at least two people that are
comfortable moving large and heavy objects.
To unbox the machine:
1. Position the Fuse Blast’s packaging near the machine’s designated area, leaving enough
room for two people to comfortably maneuver throughout the area. Stand the packaging
upright and ensure it is level. Ensure there is 2 m (6.6 ft) of clearance in front of the packaging
for unloading the Fuse Blast.
2. Cut and remove the outer strapping securing the packaging.
3. Remove the eight clips securing the exterior cardboard shell. Retain all fastening hardware
and packaging for future use.
4. Open the machine’s box from the top by removing the lid, then consecutively remove the
two C-shaped shells from the left and right sides.
5. Remove the three protective foam core supports from inside the machine.
6. Locate and remove the accessory box from the front of the machine.
7. Locate and remove the power cable box from the right side of the machine.
8. Locate and remove the ramp from the package.
9. Attach the ramp to the pallet. Align the top edge of the ramp to the front edge of the pallet.
Using the velcro attached to the ramp, secure the ramp to the pallet in front of the Fuse
Blast. The ramp surface should not be above the pallet platform.
10. Remove the bottom protective foam core support.
11. Rotate the wheel nuts clockwise to release the wheels.
12. With two people, carefully roll the machine o the pallet and into its workspace.
13. Once in position, lock the wheels on the feet to prevent the Fuse Blast from moving.
14. Remove any additional wrapping and packaging from the Fuse Blast.
15.
Open the blasting chamber door and remove the Fuse Blast tumbler basket from the
packaging. Using two hands, carefully slide the tumbler basket onto the tumbler basket shaft.
16.
Install the media blast gun onto the blast arm. Ensure that the blast gun fits snugly on the blast arm.
17.
Place the foot pedals underneath the Fuse Blast. Plug them into the connector on the
back of the unit.
18.
Remove the grounding strip from the accessories box and attach it to the front of Fuse Blast.
19. Attach your compressed air supply to the Fuse Blast using the compressed air inlet (1/4”
quick disconnect coupling), with a compressed air supply regulated to at most 120 psi.
20.
Remove the power cord from the accessories box and connect the machine to power.
The original packaging is designed to be kept and reused for transporting or shipping
the machine for service. Save the complete packaging including any inserts for your
convenience.
CAUTION
NOTICE
To Next Page
Loading...
