Formlabs Fuse Blast - Table of Contents

Table of Contents
1 Preface ..................................................................8
1.1 Read and retain instructions ................................................8
1.2 Obtaining documentation and information ...................................8
2 Introduction .............................................................10
2.1 Intended use .............................................................10
2.2 Technical specifications ....................................................11
2.3 Product components. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
2.4 Fuse Blast user interface ..................................................14
3 Safety ...................................................................15
3.1 Component and subsystem safety .........................................16
3.2 Personal protective equipment (PPE) .......................................17
3.3 Specification of tools to be used ...........................................17
3.4 Emergency and exceptional situations ......................................17
4 Preparation and setup ....................................................19
4.1 Location and environs ....................................................19
4.2 Power and networking ...................................................20
4.3 Unboxing the machine ................................................... 20
4.4 Accessing the serial name. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
4.5 Installing the machine .................................................... 22
4.6 Setting up a network connection .......................................... 23
4.7 Updating firmware ....................................................... 24
4.8 Transporting the machine ................................................ 24
5 Usage .................................................................. 27
5.1 Operational environment ..................................................27
5.2 Filling the media hopper ..................................................27
5.3 Cleaning printed parts ................................................... 28
5.4 Emptying the waste hopper ...............................................31
5.5 Emptying the media hopper .............................................. 32
5.6 Managing the machine ....................................................33