Maintenance | 39
Do not use a wire brush or you may damage the blast gun.
8. Clean the blast gun nozzle down with a clean, damp toothbrush or other synthetic fiber
brush.
9. Dry the blast gun nozzle with a new paper towel. Ensure the blast gun nozzle is completely
dry before reinstalling.
10. Screw the blast nozzle onto the blast gun until finger tight, and replace the blast gun on
the blast gun arm.
If these steps do not resolve the clog, please contact Formlabs Support for more details.
Follow specified maintenance procedures when unclogging the blast gun nozzle or
tubing.
NOTICE
To Next Page
Loading...
