Fortinet FortiGate 50A User Manual

Getting started Factory default FortiGate configuration settings
FortiGate-50A Installation and Configuration Guide 23
Factory default NAT/Route mode network configuration
When the FortiGate unit is first powered on, it is running in NAT/Route mode and has
the basic network configuration listed in Tabl e 3. This configuration allows you to
connect to the FortiGate unit web-based manager and establish the configuration
required to connect the FortiGate unit to the network. In Tab le 3 HTTPS management
access means you can connect to the web-based manager using this interface. Ping
management access means this interface responds to ping requests.
Factory default Transparent mode network configuration
If you switch the FortiGate unit to Transparent mode, it has the default network
configuration listed in Tabl e 4 .
Factory default firewall configuration
The factory default firewall configuration is the same in NAT/Route and Transparent
mode.
Table 3: Factory default NAT/Route mode network configuration
Administrator
account
User name: admin
Password: (none)
Internal interface
IP: 192.168.1.99
Netmask: 255.255.255.0
Management Access: HTTPS, Ping
External interface
Addressing Mode: DHCP
Management Access: Ping
Table 4: Factory default Transparent mode network configuration
Administrator
account
User name: admin
Password: (none)
Management IP
IP: 10.10.10.1
Netmask: 255.255.255.0
DNS
Primary DNS Server: 207.194.200.1
Secondary DNS Server: 207.194.200.129
Management access
Internal HTTPS, Ping
External Ping
Table 5: Factory default firewall configuration
Internal
Address
Internal_All
IP: 0.0.0.0 Represents all of the IP addresses on the internal
network.
Mask: 0.0.0.0
External
Address
External_All
IP: 0.0.0.0 Represents all of the IP addresses on the external
network.
Mask: 0.0.0.0

Fortinet FortiGate 50A Specifications

General

Brand	Fortinet
Model	FortiGate 50A
Category	Firewall
Language	English