How to set up your FortiWAN Web UI Overview
enforcearp: Force FortiWAN's surrounding machines to update their ARP tables
enforcearp
Sytem will send ARP packets to update their ARP tables. This is for cases where after the initial installation of
FortiWAN, machines or servers sitting in the DMZ are unable to be able to connect to the internet.
httpctl: Control web server for Web User Interface
httpctl [restart|showport|setport [PORT]]
System will restart the web server running on FortiWAN for the Web UI, or display the port number occupied by the
web server, or reset the specified port number to the web server.
logout: Exit Console mode
logout
Exit the Console mode. The system will re-confirm, press [y] to proceed or [n] to cancel.
ping: Test network connectivity
ping [HOST] [LINK] [IDX]
Ping a HOST machine to detect the current WAN link status. HOST is the machine/device to be pinged. The LINK
parameter can be WAN, LAN or DMZ. If the LINK is WAN then also specify the WAN port number.
Example: "ping www.hinet.net wan 1" [Enter] to ping www.hinet.net via WAN #1.
Note: If domain name is used in the HOST parameter, DNS Server must be set in the Web UI [System]->[Network
Settings]->[DNS Server] (See "Set DNS server for FortiWAN").
For more on ICMP related error messages please refer to other ICMP/PING materials.
reactivate Reset to factory default and base bandwidth grade.
reboot: Restart FortiWAN
reboot | reboot [-t [SECOND]]
Restart FortiWAN. Type "reboot -t X" [Enter] to restart the FortiWAN after X amount of seconds.
Example: :reboot -t 5" [Enter] to restart the system in 5 seconds.
resetconfig: Restore to factory defaults
resetconfig | resetconfig [IP ADDRESS/NETMASK]
System will re-confirm, press [y] to proceed or [n] to cancel.
Type “resetconfig [IP address/Netmask]” to specify IP configuration to LAN port from resetting system to factory
default. Example: command “resetconfig 10.10.10.1/255.255.255.0” resets system to factory default, and the IP
configuration of LAN port becomes to 10.10.10.1 / 255.255.255.0 after system comes back up. IP configuration of
LAN port returns to 192.168.0.1/255.255.255.0 if system is reset without specification. Note that resetting system with
specification on LAN port disables all the WAN links by default.
29 FortiWAN Handbook
Fortinet Technologies Inc.
To Next Page
Loading...
