Web UI Overview How to set up your FortiWAN
resetpasswd: Reset FortiWAN's Administrator and Monitor passwords to factory default
resetpasswd
System will re-confirm, press [y] to proceed or [n] to cancel.
setupport: Configure the transmission mode for all the FortiWAN port(s)
setupport [SHOW] | setupport change [INDEX] [SPEED] [MODE]
Type "setupport show" shows the current transmission modes for all the network ports.
Type "setupport change" [INDEX], then type "auto" [Enter] to change the index network port into AUTO mode.
Type "port-config change" [INDEX] [SPEED] [MODE] [Enter] to change the index network port into a specific
transmission mode.
INDEX: 1, 2, 3...
SPEED: 10, 100, 1000
MODE: half, full
Example: "setupport show" [Enter]
"setupport change 1 auto" [Enter]
"setupport change 2 100 full" [Enter]
Note:
Not all network devices support full 100M speed.
This command has no effect on fiber interface.
The INDEX is the port number of the FortiWAN port interface; exact number varies according to product models.
shownetwork: Show the current status of all the WAN links available
shownetwork
Display WAN Type, Bandwidth, IP(s) on Local/WAN/DMZ, Netmask, Gateway, and WAN/DMZ Port.
Example: "shownetwork" [Enter]
Note: This Console command can only show the current network status. This setting can be changed in the Web UI
under “Network Settings”.
showtrstat Display tunnel status
showtrstat [TR GROUP NAME]
Display the status of specified tunnel group.
sslcert: Set or unset SSL certificate for FortiWAN WebUI
sslcert show | sslcert set
Type “sslcert show” [Enter] to display current SSL certificate that FortiWAN WebUI is working with.
FortiWAN Handbook
Fortinet Technologies Inc.
30
To Next Page
Loading...
