9
5. Wiring
• Pass the wire out through the gap at the base, or through a drilled hole.
• Connect the camera to your LAN (Local Area Network of Internet router) via
Ethernet cable.
• Power on the device.
6. Turn the angle of the lens manually.
7. Finally, fasten the cover and the base together with screws.
NOTE: Do not block the Array LED when rotating the casing, so as to not affect the night
vision.
6. Important Notice
• Camera Username & Password
The camera username & password are used to access and manage your camera. Having
a strong can significantly improve the security of your camera.
If you have forgotten either of them, please press the “Reset” button and hold it for
more than 10 seconds while the camera is powered on. After release the button. The
camera will automatically reboot and the default settings will be restored.
You can then reconnect the camera by following this Quick Setup Guide.
• Foscam Cloud Service Account Username & Password
Your Foscam Cloud service account and password may be used to access both the
Foscam App and then Foscam Cloud service website. Therefore, you can register your
account username & password on either one.
To Next Page
Loading...
