Foscam FI9803 - RS485 Configuration; Firewall

www
www
.foscam.co
.foscam.co
m
m
Shenzhen
Shenzhen
Foscam
Foscam
Intelligent
Intelligent
Technology
Technology
Co.,
Co.,
Limited
Limited
Tel:
Tel:
86
86
755
755
2674
2674
5668
5668
Fax:
Fax:
86
86
755
755
2674
2674
5168
5168
66
4.7.2 RS485 Configuration
This camera supports the standard 485 cradle head protocol (PELCO-D and PELCO-P). Please configure the
RS485 protocol corresponding information first, or else the cradle head may cannot work.
Figure 4.66
4.8 Firewall
This section explains how to control the access permission by checking the client PC’s IP addresses. It is composed of
the following columns: Block access from these IP addresses and Only allow access from these IP addresses.
Figure 4.67
Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP addresses at most, only those
clients whose IP addresses listed in the Only allow access from these IP addresses can access the Network Camera. If
you select Block access from these IP addresses, only those clients whose IP addresses are in the IP list cannot access the
Network Camera.
Click Save to take effect.