Fostex R8 - Error Massages

с) Entering a New Memory or Auto Return Point
Error Messages
The RB is programmed о display certain "eror massages’
оп the TAPE TIME counter to show you when tne transport
is operative (‘shutoff error) and fo wam you of mistaken
operation during data memorizaton (“оте mode errors)
A) Shut-Off Error.
Wher the tension arm guides have dropped to their lowest
positon, thus shutting of the tape transpor, the ‘allowing er-
тог message Селог t") appears on the TAPE TIME Черау
Te qu
Elrir Е
Те be ableto use the tape transport again, remove tape slack
by rotating either or both reels by hand.
В) Store Mode Errors
Al o! these error messages show that you cannot store the
current input dala. Check the data and repeat entiy to cor
fect t
e El f
Indicates that the input cala is not suitable as an auto return
point and therefore cannot ое stored,
Error 1)
Input
Display
Input
Display
E
R
Т
1
Lj
(|?
Pa
ПР
E
ШЕ
[
ПРЧЕ
-iig
[=]
ПРЕ
5
-|[qses5
|
=le
eg)
tae
5
:
Opa
ae
5
l
WE OTE gels REETA UN
further above.
Eror 2)
9 [Elric e
‘Appears when the dala on Пе MEMORY display you have
attempted o memoize contains symbols other than
numbers.
Er-
J|
ез
Appears when the data on the TAPE TIME counter you have
attempted го stow contains symbolo other than numbers.
@ |Elrir 4
e lea Лес cua wie
SRE ee eee sce
(Eror 4)
Li