Foundations LX6 - Parking Brake Operation; Runaway Brake Operation

Parking Brake Operation.
WARNING
14
• Parking brake and runaway brake should both be engaged when
stroller is stopped and when loading and unloading children.
To lock parking brake:
1. Apply runaway brake by releasing runaway
brake bar (Fig. 4).
2. Press down on parking brake lock bar on the
rear axle assembly into locked position (Fig. 1).
3. Check that wheels are locked.
4. Ensure both jam nuts on runaway brake
cable are secure. Make sure brake lever
on each wheel must be fully engaged
on brake gear. (See “Runaway brake
Cable Operating and Adjustment
section”.)
To unlock parking brake:
1. Place toe under parking brake lock
bar and lift up into unlocked position
(Fig. 2).
Runaway Brake Operation:
To release runaway brake:
1. Pull runaway brake bar back and hold
runaway brake bar against stroller handle.
Released position is for use while
pushing stroller (Fig. 3).
To apply runaway brake:
1. Apply runaway brake by releasing runaway
brake bar (Fig. 4).
Fig. 1
Fig. 2
Fig. 4
Fig. 3
• The runaway brake is designed to stop the
stroller in the event of a loss of control.
NEVER disconnect or override the operation
of the runaway brake.
Parking
Brake
Lock Bar
Stroller
Handle
Runaway
Brake
Bar
WARNING