33
WARNING:
Your mitre-saw’s electrical system is equipped with an undervoltage relay which
automatically opens the circuit when the voltage falls below a minimum pre-established limit and
which prevents the self-reset of the machine functions when voltage returns to normal levels. If
the machine stops involuntarily, do not be alarmed and make sure that there has not been a
voltage failure in the electrical system.
MACHINE DESCRIPTION (Fig. 1)
The mitre-saw machine consists of three basic parts: the machine body complete with motor
6
,
which is integrated into the base
3
by means of the joint
4
and the swivel support
5
, and the
upper work unit, consisting of the workbench
12
, the rest square
14
and the movable protective
cap
13
.
The base
3
is used as a support when cutting and butting operations have to be carried out in
the different available angles; the upper table is used as a support when trimming or sectioning
large planks of wood, and especially when cutting wood along the grain.
SUITABLE USE
It can cut:
a. HARD AND SOFT, DOMESTIC AND EXOTIC WOOD BOTH LONGITUDINALLY AND
TRANSVERSALLY;
- and with appropriate adjustments (specific blade and clamps
only in mitre saw mode
):
- PLASTICS
- ALUMINIUM AND ALUMINIUM ALLOYS
UNSUITABLE USE
- Do not cut FERROUS MATERIALS, STEEL AND CAST IRON OR ANY OTHER MATERIAL
NOT MENTIONED ABOVE AND IN PARTICULAR FOODSTUFFS.
- Do not use it as a CIRCULAR SAW WITHOUT PROTECTION.
6
To Next Page
Loading...
