32
Double insulation. This symbol means that you cannot get at any element carrying
the electrical current without using a tool. Tools which have this symbol do not have
any earthing protection systems.
Keep your hands away / dangerous area
ELECTRICAL CONNECTIONS
ELECTRICAL CONNECTIONS
Use 230 V 50 Hz alternate voltage to supply your machine. Ensure that the power supply
corresponds to this voltage, that it is protected by a differential and magnetothermal switch,
and that the earthing system is efficient. If your machine does not work when connected to a
socket, check carefully the power supply features.
EXTENSION LEADS
Only use three conductors extension cables, with a plug with two plugs and a earthing contact
and sockets with two holes and a earth corresponding to the plug of the tool. When using an
electric tool at a remarkable distance from the power supply, use an extension lead with
sufficient dimensions to transport the current which the tool needs. If the extension lead has
not the sufficient dimensions a voltage drop can occur, thus causing an overheating and a
voltage loss. You can only use extension leads which are in compliance with CE standards.
Extension lead length: up to 15 m
Cable dimensions: 3 x 2,5 mm²
Before using any kind of extension lead, check that it has not bare wires and that the
insulation is not cut or worn. Repair and change immediately it if it is damaged or worn.
WARNING:
Extension leads must be arranged away from the working area in order that they do not come
into contact with the workpieces, the tool or other parts of the machine, thus creating possible
risks.
WARNING:
KEEP THE TOOLS AND THE EQUIPMENT AT A SAFE DISTANCE FROM CHILDREN
Serial number / Year of production
To Next Page
Loading...
