Fox F36-075 - Page 35

35
REMOVAL OF PACKAGE (Fig. 2)
The parts included in the package are:
1 – Mitre saw
2 – Wrenches for replacing the blade
3 – 5 mm Allen wrench
4 – Workbench extensions (n°2)
5 – Horizontal clamp
6 – Additional lower protection
7 – Pusher
8 – Mitre gauge included in the fence
9 – Swivel locking knob
10 – Feet extensions
Remove the mitre saw and all the parts from the package, check if there are any missing or
damaged parts.
In case there are any faulty or damaged parts do not use them in order not to compromise the
efficiency and the safety of the machine. To change faulty parts consult an after sales centre.
In order that the mitre saw perfectly works, you must assemble the various parts, for
which you can find a detailed explanation later on.
MACHINE PARTS’ DESCRIPTION (Fig. 3)
i. Control handgrip
ii. Main switch button
iii. Base
iv. Body/base swivel joint
v.Rotating support
vi. Motor
vii. Blade
v
iii. Swivel locking knob
ix. Head release button
x.Moving protective cap
xi. Moving protective cap
xii. Upper workbench
x
iii. Upper moving protective cap
x
iv. Bearing bracket
xv.Bearing feet
x
vi. Locking pin
v
ii.
Pointer
v
iii. Fence
x
ix. Main switch locking device
xx.Workbench extensions
27 Horizontal clamp
Fig. 2
1
2
3
4
5
6
7
16
9
10-11
12
13
14
15
8
19
Fig. 3
17
20
18
27