48
EN
1. Turn the workbench and its base upside-down on a piece of cardboard in
order to protect its surface.
2. Remove the 4 safety screws located on the base in order to remove the lower
plate.
3. Remove the cardboard and the protection polystyrene around the motor and
the blade (this protection is necessary during transport).
4. Then put the plate in its starting position and tighten the 4 lock screws.
Remove the saw and all other parts from the packaging and check that nothing is missing or damaged.
In case there are faulty or damaged parts, do not use them in order not to compromise the efficiency and the safety
of the tool. Consult an authorized after sales service to replace any faulty parts.
To use the table saw, you must assemble some parts. You can find a detailed explanation on how to assemble
these parts later on.
We recommend you to read carefully the assembly instructions and to follow them to the letter.
To Next Page
Loading...
Need help?
General
