3
36
This item is used to set a start limit of temperature. The fan will start to spin when the
temperature exceeds the start limit. The default value is [035].
► Start PWM Value
It allows you to set an initial PWM value to drive the fan when the temperature reaches “Start
PWM Temperature” value.
► Slope PWM Value
It is used to set a slope value in PWM/Temperature diagram. The PWM value is subject to the
temperature input value by linear changing.
BIOS Security Features
CMOS Setup Utility - Copyright (C) 1985-2011, American Megatrends, Inc.
BIOS Security Features
Security Settings
Help Item
Supervisor Password : Not Installed Enter or change the
User Password : Not Installed password.
Change Supervisor Password
[Press Enter]
Boot Sector Virus Protection [Disabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Press Enter]
► Change Supervisor Password
This item is used to install or change supervisor password.
After you input Supervisor password, it then will ask you to
input user password optionally.
If you have installed the Supervisor Password, the following
items will appear:
► Boot Sector Virus Protection
This item is used to enable/disable the boot sector virus protection.
Enter New Password :
To Next Page
Loading...
Need help?
General
