5
82
5-4 Creating a Bootable Array- Install a New Windows XP
Assume a Mirrored array (232.88GB) was created as introduced in section 5-3, after
the system restarts :
1. Press [DEL] to enter BIOS Setup during POST.
2. Insert the Windows installation CD into the optical drive.
3. Set the “1st Boot Device” to “CD/DVD”, save changes and exit BIOS.
4. The computer will reboot, and it will start installing Windows Operating System.
Watch the screen carefully, when the following picture appears, press [F6] key
immediately. If you forgot to do this, PC will go to an fatal blue screen, and you
may need to reboot the system again. PC may not respond to your [F6] input
immediately, and it keeps loading les until the next screen displays.
Windows Setup
Press F6 if you need to install a 3rd party SCSI or RAID driver.
CMOS Setup - Copyrigtht (C) 1985-2011, American Megatrenda, Inc.
Boot Device
1st Boot Device
[ CD/DVD] Item Help
2nd Boot Device
[Removable Dev.]
3rd Boot Device
[Network] Specifies the boot
4th Boot Device
[Hard Disk] sequence from the
available devices.
A device enclosed in
parenthesis has been
disabled in the
corresponding type
menu.
↑↓→←:Move Enter:Select +/-/ :Value F10:Save ESC:Exit F1:General Help
F9: Optimized Defaults
[CD/DVD]
To Next Page
Loading...
Need help?
General
