Recommend leaving this BIOS feature at the default [Enabled] setting.
► SATA Controller
This option is used to enable/disable function of SATA drives connected to the SATA ports.
MCP SATA Mode
► SATA Operation Mode
This item is used to set the operating mode of your SATA ports. The available options are:
[IDE] - This congures the SATA ports to support legacy PATA mode or SATA mode.
[AHCI] - The Advanced Host Controller Interface (AHCI) specication describes the register
level interface for a Host Controller for Serial ATA. The specication includes a description of
the hardware/software interface between system software and the host controller hardware.
AHCI provides more advanced features including SATA features, but some SATA drives may
not support AHCI, unless they are labeled with AHCI support in its specication.
If your motherboard supporting AHCI, and you have a SATA device, which also supports AHCI,
then you can select IDE option to have fair performance (only PATA, SATA level), or you can
select AHCI to get its best performance.
[RAID] - When you enable RAID, it means all your SATA drives must also support AHCI.
With your motherboard and SATA hard disk both supporting AHCI, you had better set
this BIOS setting to AHCI, then install your Operating System (such as Windows XP).
Later, if you ever change this BIOS setting to IDE, OS still can run.
But if you at the rst time set this setting to IDE, then install the Operating System.
Later, if you change this BIOS setting to AHCI, this operating system can not run.
W
A
R
N
I
N
G
!
Phoenix - AwardBIOS CMOS Setup Utility
MCP SATA Mode
SATA Operation Mode [IDE] Item Help
x SATA Pri-Master RAID Disabled
x SATA Pri-Slave RAID Disabled Menu Level ►
x SATA Sec-Master RAID Disabled
x SATA Sec-Slave RAID Disabled
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
IDE