Foxconn M7VMX series - Integrated Peripherals

3
31
Integrated Peripherals
► OnChip IDE Devices / MCP SATA Mode / OnBoard Devices / SuperIO Devices / USB
Devices
Press <Enter> to go to relative submenu.
OnChip IDE Devices
► OnChip IDE Channel
This option is used to enable/disable function of IDE drives connected to the PATA interface.
► IDE DMA Transfer Access
[Disabled] : to disable DMA transfers for all IDE drives. They will revert to PIO mode transfers.
[Enabled] : to enable DMA transfers for all IDE drives. The proper DMA mode will be detected
at boot-up. If the drive does not support DMA transfers, then it will use PIO mode instead.
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
► OnChip IDE Devices [Press Enter] Item Help
► MCP SATA Mode [Press Enter]
► OnBoard Devices [Press Enter] Menu Level ►
► SuperIO Devices [Press Enter]
► USB Devices [Press Enter]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
Press Enter
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Devices
OnChip IDE Channel [Enabled] Item Help
IDE DMA Transfer Access [Enabled]
SATA Controller [Enabled] Menu Level ►
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
Enabled