● Reset Service Interval Insp1(Days)
● Reset Service Interval Insp2(Days)
● Reset Days And Km After Service
● Pre-set Value Oil(Km)
● Pre-set Value Oil(Days)
● Pre-set Value Insp1(Km)
● Pre-set Value Insp1(Days)
● Pre-set Value Insp2(Km)
● Pre-set Value Min Oil(Km)
● Pre-set Value Max Oil(Km)
● Pre-set Value Oil Quality(Km)
● Read, Set Km Remaining To Oil Service
● Read, Set Days Remaining To Oil Service
● Read, Set Km Remaining To Insp1
● Read, Set Days Remaining To Insp1
● Read, Reset Km After Oil Service
● Read, Reset Days After Oil Serv.
● Read, Reset Days After Insp1
● Read, Reset Km After Insp2
NOTE
● Available functions will vary depending on the type of electronic instrument panel.
● The service intervals are measured/set/reset in kilometers even when the speedometer shows
miles. The scan tool will calculate the equivalence in miles when showing kilometers.
● The service intervals can be changed in steps of 100 kilometers only. It is not always possible to
set them to a round number of miles. The only exceptions are some new instrument panels,
Type H and J, which use miles as base value.
● Depending on the type of Instrument Panel, up to three different types of service intervals are
available
- Oil Service – oil change
- Inspection 1 – yearly inspection
- Inspection 2 – bi-yearly inspection
● Depending on the type of Instrument Panel, the limit values for the above type of inspections are
in kilometers and/or days.
To perform an electronic service interval reset:
1. Select Oil Service from Maintenance menu.
Figure 4-55 Sample VW Menu Screen
2. The Oil Service menu displays.
To Next Page
