24
10.1 Troubleshooting
No water in the water tank
Fill the water tank with water.
The water tank is not installed in place
Push into the water tank again so
that the water tank is flush with the
inner cavity plane
Replace the solenoid valve or notify
the manufacturer for repair
The control
panel is not
operational
In the state of child lock
The switch board is broken
Notify the manufacturer to repair
Over-temperature failure of liner
temperature sensor
Notify the manufacturer to repair
Over-temperature fault of heating
plate temperature sensor
Unplug for cooling or notify the
manufacturer for maintenance
The temperature rise of the cavity is
below 3K within 10 minutes after
starting
Notify the manufacturer to repair
The evaporator temperature is below
100℃ after starting for 5 minutes
Notify the manufacturer to repair
The cavity temperature probe is not
connected to the power supply
Notify the manufacturer to repair
The temperature probe of steam
generator is short-circuited
Notify the manufacturer to repair
XI. Packing list