FRC DFA400 - PROGRAMMING

DFA400 Rev150730
18
PROGRAMMING
The program access mode is selected and inputs are made using the two pushbutton
switches on the front of the display module. The digital display shows stored data and
operator inputs. (Refer to Figure 1.)
Note: When entering codes in the program access mode there is a time-out
feature that requires an operator input every three seconds. If an input is
not detected within ve seconds the program returns to normal operation.
Inputs
The two pushbutton switches on the front of the display module allows the operator
access to stored data and program functions.
Both the MODE and TOTAL buttons are used to enter program codes.
Once a program code is entered, the MODE button selects the digit to change and
the TOTAL button changes the digit or option choice.
Display Module Identication Mode
When in the module identication mode, the digital display shows the module
serial number, manufactured date, software revision, function code, and ID number.
The module identication mode is a display-only mode and no changes can be made
to program information.
Note: There is a time-out feature that returns the program to normal operation
in ve seconds if input is not detected.
Select Display Module Identication Mode
Turn on power. Press and hold the MODE button, then press the TOTAL button
and release both. The program enters the display module identication mode and the
display shows the module serial number. Press the MODE button a second time and
the display shows the manufacturing date. Each time the MODE button is pressed the
display shows the next block of stored identication data.
If the button is not pressed for ve seconds the program reverts to normal operation.