FRC DFA400 - General Description; Components

DFA400 Rev150730
6
GENERAL DESCRIPTION
Components
The owmeter kit consists of the following components:
Display Module
Paddlewheel Flow Sensor and Mounting Assembly
Cables
Display Module
The display module is waterproof and has dimensions less than 3 1/4 inches high
by 3 1/4 inches wide by 2 inches deep. All controls and indicators are located on the
front of the display module. (Refer to Controls and Indicators.)
Paddlewheel Flow Sensor
The ow sensor provides an input signal to the display module proportional to
discharge ow rate. It is mounted in the discharge piping. Placement of the sensor in the
piping is critical to obtain accurate ow rate information. Refer to Installation Section
for detailed information on mounting locations. The electrical connector is waterproof
and molded into the ow sensor housing.
Cables
A standard cable is provided. (Refer to Wiring Section.)