To Next Page

To Previous Page

DFA400 Rev150730

Error Code E202

An invalid program code has been entered. Re-enter the program code when the

digital display resets.

Error Code E204

There is no signal from the sensor. This code is displayed only when in a calibration

program. Troubleshoot the sensor and the associated wiring.

Error Code E206

A selected calibration point is to close to the previous point. (There is less than 5%

difference between two calibration points.) Select a different point to continue with

the calibration procedure.

Error Code E208

There is a failure with the internal memory of the module. Contact factory if this

error code is displayed.

Error Code E210

The number of available calibration points have been exceeded. Exit the

calibration program.

Exit Program Access Mode

Press and hold the MODE button and then press the TOTAL button and hold them

until the display shows four dashes. Release the buttons and enter a new code, or after

ve seconds the program times out and returns to normal operation.

Questions and Answers:

Need help?

Do you have a question about the FRC DFA400 and is the answer not in the manual?

FRC DFA400 Specifications

General