FRC NightMaster - Install Quick Release Bracket for Portable Model 700

LGT100 Rev0309
22
Install Quick Release Bracket for Portable Model 700
The quick release brackets will hold an FRC portable lamphead securely to the
vehicle or a telescopic pole. Pull the quick release knob to install or remove the portable
light.
703 Quick Release Bracket for Flat Surface Mounting
1. Place the 703 bracket in position to check for lamphead t.
2. Mark the mounting hole locations. Use the bracket as template.
3. Dill the mounting holes. The mounting bracket is predrilled for 5/16
hardware.
4. Pull the quick release knob to install the portable light on the bracket.
705 Quick Release Bracket for Pole Mounting
Note: If the 705 quick release is to be retrot onto an existing pole the
lamphead to pole adapter P/N LT100 must be removed and replaced with
the 705 adapter P/N X-LT214-705.
1. Place adapter on top of pole and tighten two set crews.
2. Place the 705 into the adapter and tighten the set screw.
3. Pull the quick release knob to install the portable light on the bracket.
703 Quick Release Bracket
for Flat Surface Mounting
705 Quick Release Bracket
for Pole Mounting
Optimum
OPA700
Focus
FCA700
NightMaster
LTA700