FRC NightMaster - No-Scratch for Model 530 Telescopic Pole; Install No-Scratch Guide Collar and Guide Rail; Install No-Scratch Rubber Bumpers (Focus Lamphead Only)

LGT100 Rev0309
30
NO-SCRATCH FOR MODEL 530 TELESCOPIC POLE
Install No-Scratch Guide Collar and Guide Rail
1. Install the telescopic pole according to instructions for side mouint telescopoic
pole.
Note: It is recommended that the Steady Rest Bracket be installed with the
No-Scratch option.
2. Use the guide rail as a template and mark the mounting holes.
Note: The slot in the guide collar has to engage the guide rail when the pole is
in the down position. The collar mounts on the handle of the pole, ensure
the guide rail will be in the correct position before drilling mounting
holes.
3. Drill holes and secure the guide rail.
4. Place the guide collar in position on the pole handle. Before tighting the two
screws ensure that when the slot engages the rail the lamphead is in the correct
position.
5. Tighten the screws.
Install No-Scratch Rubber Bumpers (Focus Lamphead
Only)
The rubber bumpers help prevent scratching and denting by eliminating any metal-
to-metal contact between the rear of the lamphead and the apparatus body surfaces
when the pole is lowerd.
1. Place the rubber bumper in position on the bottom of the end cooling n.
2. Using the bumper as a guide, drill a hole through the cooling n with a number
30 bit.
3. Place the backing plate on the rivet and insert the rivet thru the bumper and
mounting hole.
4. Secure the bumper with the rivet.
No-Scratch Guide Rail
and Guide Collar for
530 Telescopic Poles
Shown with a Steady
Rest Bracket Installed
No-Scratch
Rubber Bumpers
for Focus
Lampheads