FRC NightMaster - Install Brow Mount Models 800, 850

LGT100 Rev0309
24
Install Brow Mount Models 800, 850
Before mounting check the identication label on the lamphead for specic voltage
and current requirements. Check that the length of the power cord is correct.
Note: Before drilling holes place the light in position to check for t. Ensure
that the lamphead will clear all obstructions.
1. Place the light in position.
2. Mark the mounting hole locations and through hole for the wiring. Use the
lamphead and attached brackets as a template.
3. Dill the mounting holes. The mounting brackets are predrilled for 1/4-20 or
5/16-18 hardware.
4. Place the four rubber washers in position at each mounting hole.
5. Secure the light.
6. Ensure that approved strain relief for the wiring is installed.
Wiring
12/24 VDC
Connect the BLACK wire to GROUND.
Connect the RED (or WHITE) wire to POWER.
120/240 VAC
Connect the GREEN wire to chassis GROUND.
Connect the WHITE wire to RETURN.
Connect the BLACK wire to POWER.
FCA850
Flat
Mount
OPA800
Contour
Mount